KIA Diagnostic softwares for x431 series V44.22
Date：
2018-02-08
Clicks:
160
Compared with the previous version: 1.new functions All special functions under the newly added 2016~2017 models, see the details below. 2.optimized functions The diagnostic software structure has been optimized. 3.fixed bugs none. New functions : 1. Added the ECM system special functions Auto Detected Configuration Reset, Belt Timing Test, DPF Service Regeneration, ECT Circuit Test, Engine Test Function, Essential Work after Compoment Replacement, EVAP Test, Fuel line air removal, Idle CO Adjustment, Injector Specific Data, ISA Short trip Test, MAF Circuit Test, MAF Short trip Test, Read VIN, Write VIN , Resetting Adaptive Values, etc for the newly 2016~2017 models in General area and USA area. 2. Added the TCM system special functions CLEAR CAN Learnable Status, DCT Learning Function, EOP Control Adaptation, Resetting Auto T/A Values, TCU Sub Rom Reset for the newly 2016~2017 models in General area and USA area. 3. Added the ABS system special functions ABD/ASR Pressure Increase, AEB Variant Coding, Auto Detected Configuration Reset(ESP(ESC) Only), HCU Air Bleeding Mode, High Pressure Release Mode, Longitudinal G Sensor Calibration(HAC/DBC Only), Radar Sensor Alignment (SCC/AEB), Pressure Sensor Calibration, Variant Coding, SAS CALIBRATION(CAN-ESP Only), Steering Angle Sensor Calibration, etc for the newly 2016~2017 models in General area and USA area. 4. Added the SMK system special functions Antenna Status Check, Current FOB Key Check, ESCL OPEN STATUS CHECK, ESCL STATUS INFORMATION, FOB KEY STATUS INFORMATION,Neutralization Mode,Serial Communication Line Check, Smart Key Code Saving, SMK STATUS INFORMATION, etc for the newly 2016~2017 models in General area and USA area. 5. Added the BCM system special functions Power Tailgate Mode Configuration, Seat Limit Position Setting, Service Reminder Setting, Siren System Identification (Only UK), Steering Limit Position Setting, UIP System Identification (Only UK), User Option, Wiper Setting Position Calibration Mode, HUD Calibration, CLU Variant Coding for the newly 2016~2017 models in General area and USA area. 6. Added the LDWS system special functions BSD Radar Calibration, BSD variant code reading, BSD variant coding, LKAS/LDWS Variant Coding, Variant Coding,SPC Calibration, SPTAC Calibration for the newly 2016~2017 models in General area and USA area. 7. Added the HEVCS system special functions Compression pressure test of engine cylinder, E/C Fluid Pressure Cal., Engine Test Off, Engine Test On, LDC Activation Test, Electric Water Pump Control, Motor/HSG Resolver Calibration for the newly 2016~2017 models in General area and USA area. 8. Added the ECS system special functions Air Filling/Venting Setup, ALI FINISH, Auto Detected Configuration Reset(ESP(ESC) Only), ECS Air System Check, ECS Leveling Mode, ECS Variant Coding, Height sensor Calibration (Reset) for the newly 2016~2017 models in General area and USA area. 9.Added the EPS system special functions ASP CALIBRATION(CAN), EPS Type Recognition, Part exchange(Power steering ECU), Part exchange(Power steering motor) for the newly 2016~2017 models in General area and USA area. 10.Added the VMCS system special functions Electric Water Pump Control, Initialization of Automatic Resolver Offset Calibration, Read VIN, Write VIN, VMCU Variant Coding for the newly 2016~2017 models in General area and USA area. 11. Added the SRS/ AC/ CCS/ AHLS/ Driveshaft/ BMS/ SPAS /TPMS system special functions ACU/SRSCM Variant Coding, Body Sensor Reset, Pass.Airbag Realtime Info., A/C Compressor Test (ECV Type), Radar Sensor Alignment (SCC/AEB), Variant Coding, Parameter Setting & Zero position Initial, Headlamp Leveling, Parameter Download, Clutch Learning Read, Clutch Learning Reset, Clutch Learning Write, Isolation Breakdown Detection function, SOC Calibration, SPAS Variant Coding, Vehicle Name Writing, VIN Writing, Wheel Sensor ID Writing for the newly 2016~2017 models in General area and USA area.